X1 Line Connection; X21 Signaling Contact - Siemens Sinamics S120 Manual

8.6.3.2

X1 line connection

Table 8- 22 X1 line connection
8.6.3.3

X21 signaling contact

Table 8- 23
Type: Screw terminal 1_1 (Page 755)
Max. cross-section that can be connected 1.5 mm
The 2-pole terminal connector for the signaling contact is included in the Completion Kit provided.
The signaling contact can be connected with a digital input (DI) on the Control Unit or other
digital interface (PLC, SCADA). In parallel or redundant operation the failure of a Control
Supply Module is indicated in order to initiate a service call, for example.
The signaling contact operates as an isolated NO contact. When the switch is closed, the
Control Supply Module is "OK" and provides the output voltage. The switch opens in the
event of a fault "Not OK" – when the overtemperature condition is still present, after a pre-
warning, wire breakage, short-circuit etc. The Control Supply Module is correspondingly
switched off.
Booksize Power Units
Manual, (GH2), 04/2014, 6SL3097-4AC00-0BP6
Terminal Technical data
U1 Supply voltage:
3 AC 380 V ... 480 V, 50 / 60 Hz
V1
Type: Screw terminal 4 (Page 755)
W1
Max. cross-section that can be connected: 4 mm
Tightening torque: 0.5 ... 0.6 Nm
PE connection M5 screw / 3 Nm at the housing
X21 signaling contact
Terminal
1
2
8.6 Control Supply Module CSM
Technical data
Voltage: 24 V DC
Max. load current: 0.5 A (ohmic load)
2
DC link components
2
561