Siemens Sinamics S120 Manual page 749

Attaching the motor connector
The connections for the single conductors at the motor connector can be taken from the
following diagram.
①
Figure 12-29 Connections at the motor connector, screw version
The motor connector is connected as shown below.
1. Insert the individual U, V, W conductors into the associated terminals of the motor
2. Insert the individual conductors of the motor holding brake into the associated terminals
①
Figure 12-30 Attaching the motor connector screw version
Booksize Power Units
Manual, (GH2), 04/2014, 6SL3097-4AC00-0BP6
Connection for shield plate supplied with the equipment
connector (maximum cross-section for cables with end sleeves: 6.0 mm
of the motor connector (maximum cross-section for cables with end sleeves: 2.5 mm
Insulated ring cable lug
Cabinet design and EMC Booksize
12.8 Connection systems
).
2
).
2
749