Siemens Sinamics S120 Manual page 641

Table 11- 6 Installing the shield connecting plate to a 200 mm wide component using as an example internal air cooling
Loosen the lower screw.
Tighten the shield connecting plate.
Tightening torque: 6 Nm
Tools required:
● Torx screwdriver T25 for shield connecting plate
Booksize Power Units
Manual, (GH2), 04/2014, 6SL3097-4AC00-0BP6
11.1 Shield connecting plates for power supply and motor cables
Engage the shield connecting plate into
the screws and at the line/motor
connection
Installed shield connecting plate
Secure the shield connecting plate by
pulling it to the left
Accessories
641