Bracket - TOHATSU MFS25 Service Manual

1 Special Tools
....................................
2 PTT Wiring and Layout Diagram
3 Parts Layout
.......................................
Drive Shaft Housing .................................... 7-4
Swivel Bracket (Mechanical Tilt) ..................... 7-5
Clamp Bracket & Reverse Lock ..................... 7-6
Bracket, PTT & Gas Assistant........................ 7-7
Power Trim & Tilt ....................................... 7-9
Tiller Handle ............................................. 7-10
Bottom Cowl ............................................. 7-11
Shift ...................................................... 7-12
4 Inspection Items
.............................. 7-14
1) Inspection of Throttle Cable ..................... 7-14
2) Installation of Tiller Handle........................ 7-14
3) Adjustment of Co-pilot Plate ..................... 7-15
4) Removing Drive Shaft Housing .................. 7-16
5) Pulling Out Upper Mount ........................ 7-17
6) Disassembly of Drive Shaft Housing ......... 7-17
7) Inspection of Oil Strainer ........................ 7-18
8) Assembly of Drive Shaft Housing ............... 7-18
9) Installation of Drive Shaft Housing Ass'y ...... 7-19
10) Removing Steering Shaft ........................ 7-20
11) Installing Steering Shaft ........................... 7-20
7

Bracket

7-2 12) Removing Clamp Bracket (PTT or Gas Assistant Model) ... 7-21
7-3 13) Removing Clamp Bracket (Mechanical Tilt Model) ... 7-21
......
7-4 14) Installation of Clamp Bracket (PTT or Gas Assistant Model) ... 7-22
15) Installation of Clamp Bracket (Mechanical Tilt Model) ... 7-23
16) Removing PTT Unit/Gas Shock Absorber ... 7-24
17) Removing PTT Motor .............................. 7-25
18) Removing PTT Pump and Valves ............... 7-25
19) Inspection of PTT Pump and Valves............ 7-25
20) Removing Tilt Cylinder ........................... 7-26
21) Inspection of Tilt Cylinder ........................ 7-26
22) Inspection of Valve ................................. 7-27
23) Installation of PTT Pump and Motor ............ 7-27
24) Assembly of Tilt Cylinder ........................ 7-28
25) Air-Purging PTT Unit (separated from outboard motor) ... 7-30
26) Installation of PTT Unit/Gas Shock Absorber ... 7-32
27) Air-Purging PTT Unit (installed on the outboard motor) ... 7-33
28) Inspection of PTT Solenoid ..................... 7-34
29) Inspection of PTT Switch ........................ 7-35
7