TOHATSU MFS25 Service Manual page 70

Maintenance
Adjust screw-in length of cable joint y so that hole of cable
12.
joint is brought to shift arm pin u.
Screw-in remote control cable joint at lease
10mm i.
After adjusting remote control cable joint, fix it
with remote control cable fully pushed in.
Lock joint with nut i, put it on the pin, and secure with
13.
washer and snap pin o.
Check that shifting control lever e forward (F) by
14.
approximately 32 degrees (j) , where it is stopped once,
makes the gear engage, and fully shifting the lever makes
throttle valve fully open, and then, check that shifting the
lever reverse (R) by approximately 32 degrees (l), where it
is stopped once, makes the gear engage, and fully shifting
the lever makes throttle valve fully open.
Then, check that, when control lever is returned to neutral
position (N) k, throttle valve is fully closed m. Since throttle
position sensor (TPS) operates incorrectly if throttle valve
does not contact with full close stopper with the valve fully
closed, readjust cable joint position at outboard motor side
and reinstall it if the valve does not contact with full close
stopper in this case.
15. Check if throttle valve operates smoothly, and repeat steps
1. to 14. as necessary.
3-22
WARNING
u
y
y
i
i
o
i
k
l
j
e
m
25/30 2006