Installation Of Recoil Starter - TOHATSU MFS25 Service Manual

42) Installation of Recoil Starter

Reverse disassembly procedure to assemble by taking
care of the following matters.
When setting starter spring into starter case, face starter
spring outer edge hook to the right and set it into
peripheral cut of starter case.
Run starter rope through rope guide 1.
When installing reel into starter case, set projection of reel
in the internal hook of starter spring.
Apply cold resistance lithium grease to the following parts.
• Starter Spring
• Reel Center Hole
• Ratchet
• Starter Lock
• Friction Plate
Apply "Three Bond" 1342 to starter shaft bolt, and tighten
the bold to specified torque.
Starter Shaft Bolt :
6 N·m ( 4 lb·ft ) [ 0.6 kgf·m ]
When applying tension to starter spring, turn reel 4 to 5
times to direction to which the reel rotates when pulling
out starter rope (counterclockwise) .
Perform shift operation to check that recoil starter is
locked at other than neutral (N) position.
25/30 2006
1
1 Rope Guide
2
2 Friction Spring
3 Friction Plate
4 Starter Shaft Bolt
LIT
LIT
LIT
LIT
4
1342 1342
1342
3
LIT
LIT
5
5-61