TOHATSU MFS25 Service Manual page 209

3. Set both engine side and gear case side gear shifts to
neutral (N).
4. Connect shift rod and cam rod with new spring pin.
Spring Tool 3 :
P/N. 345-72228-0
• Before removing or installing propeller, be
sure to disconnect battery cables from
battery and remove stop switch lock
plate.
• When removing or installing propeller, do
not handle propeller with bare hands.
• Put a piece of wooden block between
anti-cavitation plate and propeller 4 to
prevent rotation of propeller.
5. Apply grease to propeller shaft.
6. Attach thrust holder, propeller, washer and propeller nut to
propeller shaft. Put a piece of wooden block between anti-
cavitation plate and propeller to prevent rotation of propeller,
and tighten propeller nut to specified torque.
7. Turn propeller nut to tightening direction to align one of
grooves to propeller shaft hole, and attach split pin.
If propeller nut groove cannot be aligned with split
pin hole, loosen nut and repeat steps 6 and 7.
Propeller Nut :
25 N·m (18lb·ft ) [ 2.5 kgf·m ]
8. Check gear oil level. "Refer to Chapter 3."
Perform "Inspection of Lower Unit (Air Leakage)"
in Chapter 3 if necessary.
25/30 2006
WARNING
3
OBM OBM
OBM
6
6-31