Reassembly Of Pinion Gear Nut (B Gear Nut) - TOHATSU MFS25 Service Manual

33) Reassembly of Pinion Gear Nut
(B Gear Nut)
After installing drive shaft ass'y 1, pinion gear (B gear) 2
1.
and pinion nut (B gear nut), and tighten the nut to specified
torque.
Bevel Gear B Nut Socket 3 :
P/N. 346-72232-0
Bevel Gear B Nut Wrench 4 :
P/N. 346-72231-0
Pinion Nut (B Gear Nut) :
35 N·m ( 25 lb·ft ) [ 3.5 kgf·m ]
After settling pinion gear (B gear) height and
forward gear (A gear) backlash, apply "Three
Bond 1373B" to pinion (B gear) nut thread and
tighten the nut to specified torque.
34) Assembly of Propeller Shaft Housing
1. Check that OBM grease is applied to housing ass'y oil seal.
Attach washer 1 and propeller shaft ass'y 2 to propeller
2.
shaft housing ass'y 3.
Apply grease to new O-ring 4.
3.
Apply grease to push rod 5 and ball 6, and install them to
4.
propeller shaft 2.
Attach propeller shaft housing ass'y 3 to gear case, and
5.
tighten bolts 7 to specified torque.
Propeller Shaft Housing Bolt 7 :
13 N·m ( 9 lb·ft ) [ 1.3 kgf·m ]
• Use grease to prevent ball from falling from
push rod.
• When installing housing ass'y to gear case,
tighten upper and lower bolts in 2 or 3 steps
evenly to specified torque.
25/30 2006
3
2
1373B 1373B 1373B
1373B
1
2
OBM OBM
OBM
6
5
7
1342 1342
1342
OBM OBM
OBM
1
4
3
4
6
OBM OBM
OBM
3
6-27