TOHATSU MFS25 Service Manual page 62

Maintenance
5. Remove flywheel and then key
To prevent damages to engine and special
tools, tighten flywheel puller set bolts
evenly and keep flywheel puller parallel to
flywheel while working.
Screw puller onto crankshaft end until flywheel
is disengaged from tapered section of
crankshaft.
å Flywheel Holder :
P/N. 3AC-99200-0
å Flywheel Puller :
Use puller included in the following puller kit.
∫ Flywheel Puller Kit :
P/N. 3C7-72211-1
6. Disconnect couplers (4) of alternator and pulser coils, and
then, remove alternator and coil bracket ass'y.
Remove belt tensioner cap, and loosen tensioner bolt 3 by
7.
using a tool until it can be turned with a hand.
8. Remove engine hanger.
Remove timing belt 4 from cam shaft pulley and then from
9.
timing pulley.
Do not turn timing pulley and cam shaft
pulley with timing belt removed. Doing so
can make pistons and valves interfere with
each other, resulting in damages to these
parts.
10. Check that cam shaft pulley's "
" b, and belt guide's 5 "
head's "
" d are aligned with each other respectively.
cylinder's "
3-14
CAUTION
CAUTION
" mark a and cylinder
" mark c and
å
∫
3
4
2
a
b
d
c
5
25/30 2006