Flushing With Water - TOHATSU MFS25 Service Manual

29) Flushing with Water

Touching rotating propeller could lead to injury.
Be sure to remove propeller before running
engine on the land.
Exhaust gas contains carbon monoxide,
which will cause gas poisoning. Do not
start engine with outboard motor placed in
a closed area such as boat house.
Flushing with water using drive cleaner 3
1. Remove propeller and thrust holder.
Close sub water strainer 2 with tape.
2.
Attach driver cleaner 3 to water strainer 1 area.
3.
Put water hose to driver cleaner 3 and run water.
4.
5. Set gear shift to neutral (N) and start engine.
6. Check that cooling water check port discharges water, and
run engine for 3 to 5 minutes at low speed.
7. Stop engine and stop water supply, remove driver cleaner
3, and remove tape, and then, install propeller.
Remove tape after flushing with water.
Flushing with water using flushing attachment 4 (hose adapter)
1. Remove propeller and thrust holder.
Close water strainer 1 and sub water strainer 2 with tape.
2.
Remove water plug 5 of outboard motor, and attach
3.
flushing attachment 4.
Put water hose on flushing attachment 4 and run water.
4.
5. Set shift lever to neutral (N) and start engine.
25/30 2006
CAUTION
WARNING
3
2
1
4
3
5
3-31