Power Unit
14.
Remove flywheel and key.
å Flywheel Holder :
P/N. 3AC-99200-0
å Flywheel puller :
Use puller contained in the following puller kit.
∫ Flywheel puller kit :
P/N. 3C7-72211-1
Apply forces to tools toward directions as
shown, and perform work taking care not to
allow flywheel holder to remove.
Screw puller onto crankshaft end until flywheel is
disengaged from tapered section of crankshaft.
To prevent damages to engine and special
tools, tighten flywheel puller set bolts
evenly and keep flywheel puller parallel to
flywheel while working.
15.
Disconnect alternator and pulser coil.
Remove bolts of alternator e and coil bracket r, and
16.
remove alternator and coil bracket.
5-24
CAUTION
CAUTION
å
∫
e
r
25/30 2006