Configuring The Device As An Ipv6 Tftp Client - HP 5920 series Fundamentals Configuration Manual

Step
5. Download or upload a file
in an IPv4 network.

Configuring the device as an IPv6 TFTP client

Step
1. Enter system view.
2. (Optional.) Use an ACL to
control the client's access to
TFTP servers.
Specify the source IPv6
3.
address for TFTP packets
sent by the TFTP client.
4. Return to user view.
5. Download or upload a file in
an IPv6 network.
Command
tftp tftp-server { get | put | sget }
source-filename [ destination-filename ]
[ vpn-instance vpn-instance-name ] [ dscp
dscp-value | source { interface interface-type
interface-number | ip source-ip-address } ] *
Command
system-view
tftp-server ipv6 acl acl-number
tftp client ipv6 source { interface
interface-type interface-number |
ipv6 source-ip-address }
quit
tftp ipv6 tftp-server [ -i
interface-type interface-number ]
{ get | put | sget }
source-filename
[ destination-filename ]
[ vpn-instance
vpn-instance-name ] [ dscp
dscp-value | source { interface
interface-type interface-number |
ipv6 source-ipv6-address } ] *
82
Remarks
The source IP address
specified in this command
takes precedence over the
one set by the tftp client
source command.
Use this command in user
view.
Remarks
N/A
By default, no ACL is used for access
control.
By default, no source IPv6 address is
specified. The source address is
automatically selected as defined in
RFC 3484.
N/A
The source IP address specified in this
command takes precedence over the
one set by the tftp client ipv6 source
command.
Use this command in user view.