Table of Contents
Advertisement
138
IP routing advanced configuration
Variable definitions
The following table describes the variables and values for adding an OSPF virtual interface.
Variable
Transit Area ID
Neighbor Router ID
Authentication Type
MD5 Key ID
Authentication Key
Hello Interval
Retransmit Interval
Transmit Delay
Dead Interval
Neighbour State
OSPF route information display parameters
The following section describes the display parameters for the OSPF route information located
Configuration, IP Routing, OSPF, Route Information tab
Variable definitions
The following table describes the variables and values displayed on the OSPF Route Information
panel.
Variable
IP Address
Subnet Mask
TOS
NN47928-500
NN47928-500
Value
Select the transit area ID.
This is a list of previously configured OSPF interfaces (see
configuration parameters (page
Type the router ID of the virtual neighbor.
Specifies the authentication type for an interface. Select one of the
following options:
•
None - indicates authentication is not required.
•
Simple Password - indicates a simple password is required for
authentication.
•
MD5 - indicates message digest 5 based authentication.
The default value is None.
Type the secret key used to create the message digest appended to the
OSPF packet if the authentication type is MD5.
Type the key required for authentication, if authentication is enabled on
this interface.
Type the Hello Interval.
The range is 1to 65535.
Type the Retransmit Interval.
The range is 0 to 3600.
Type the Transmit Delay.
The range is 0 to 3600
Type the Dead Interval.
The range is 0 to 2147483647.
Displays the state of the neighbor router, either Up or Down.
This field is displayed after you add an OSPF configuration.
Value
Displays the IP address of the OSPF router.
Displays the subnet mask of the router.
Displays the Type of Service (TOS) of the OSPF router
135)).
.
OSPF area
at
Advertisement
Table of Contents
