Table of Contents
Advertisement
192
SIP advanced configuration
Variable
Digital Dial Timeout
NAT Traversal
STUN Server IP
Voice Mail configuration
Mail box Enable
Server IP
Server Port
IP Type of Service Configuration
Precedence
Throughput
Reliability
Delay
Codec information configuration parameters
The following section describes the parameters for the configuration of the FXO/FXS codec
information located at
Variable definitions
The following table describes the variables and values for configuring codec information.
Variable
Select
NN47928-500
NN47928-500
Value
Type the digital dial timeout for VoIP when the pound (#) key is not
pressed.
The value ranges from 500 to 10000.
The default value is 5000 milliseconds.
The default value is Disabled.
Type the Simple Traversal of UDP through NATs (STUN) server IP
address. You can configure this IP address only when the NAT
Traversal status is enabled.
Select this check box to enable voice mail in VoIP.
The default value is unchecked.
Type the IP address of the mail server.
You can configure this field only when Mail box Enable is selected.
Type the mail server port.
The value ranges from 1024 to 65535.
The default value is 5060.
You can configure this field only when Mail box Enable is selected.
Select the IP Terms of Service (ToS) precedence value in the packets.
The value ranges from 0 to 7.
The default value is 0.
Select this check box to configure IP ToS throughput in VoIP.
The default value is disabled.
Select this check box to configure IP ToS reliability in VoIP.
The default value is disabled.
Select this check box to configure IP ToS delay in VoIP.
The default value is enabled.
,
Configuration
SIP, FXO/FXS, Codec tab
Value
Select the codec you want to configure.
.
Advertisement
Table of Contents
