Table of Contents
Advertisement
Variable definitions
The following table describes the variables and values for configuring Ethernet WAN.
Variable
Interface
Encapsulation Mode
MAC Cloning
MAC Address
IP Address Assignment
Configuring manual IP address assignment
Complete this procedure to configure the Ethernet WAN for manual IP address assignment. The IP
Address Assignment field has a default value of Manual.
Procedure steps
Step
Action
1
From the BSG navigation pane, select Configuration, WAN, Ethernet.
The WAN Configuration pane appears.
2
From the Interface list, select the required interface.
3
From the Encapsulation Mode list, select Ethernet.
4
In the WAN IP Address field, type the IP address.
5
In the Subnet Mask field, type the subnet mask.
6
In the Gateway IP Address field, type the Gateway IP Address.
7
In the Primary DNS field, type the Primary Domain Name System (DNS) IP
address.
8
In the Secondary DNS field, type the Secondary DNS IP address.
9
Click Apply.
Value
Select an Interface to be configured.
Set the encapsulation mode to Ethernet. The WAN interface operates as a
normal Ethernet interface.
Select the MAC cloning status.
Enable - the BSG uses the configured MAC address as the source of
Ethernet frames instead of the MAC address of the BSG WAN port.
Disable - disables MAC Cloning.
You can enable MAC cloning only if the Encapsulation Mode is Ethernet.
The default value is Disable.
Type the MAC address, if the MAC cloning is enabled.
Select Dynamic for the system to assign the IP address for the specified
VLAN from the Dynamic Host Configuration Protocol (DHCP) server.
End
WAN configuration
17
Configuration Guide
Advertisement
Table of Contents
