Table of Contents
Advertisement
Variable definitions
This table describes the variables that appear on the PPP Configuration page.
Variable
PPP Interface
User Name
Password
WAN IP Address
Subnet Mask
Gateway IP Address
Primary DNS Server
Secondary DNS Server
Rate limit configuration parameters (DSL)
For DSL, the rate limit should be configured. The rate limit value is based on the uplink bandwidth
of the ADSL service.
Variable definitions
The following table describes the variables and values for configuring the uplink rate limit.
Variable
Rate Limit Status
Uplink Rate Limit
T1/E1
T1/E1 appears under WAN configuration if you are connected to a BSG12tw.
T1/E1 is a digital WAN carrier facility. T1 transmits DS-1 formatted data at 1.544 MB/s and E1
transmits E1 formatted data at 2.048 MB/s through the telephone e-switching network, using
HDB3, AMI, or B8ZS coding.
You must have access read/write permission to configure T1/E1.
T1/E1 navigation
•
T1/E1 Configuration (page 90)
Value
The PPP interface for which you need to configure the IP address.
The username for the specified PPP interface, used for authentication.
The password for the specified PPP interface, used for authentication.
Displays the IP address of the WAN PPP interface.
Displays the subnet mask for the WAN interface.
Displays the Gateway IP address for the WAN interface.
Displays the IP address of the Primary DNS server.
Displays the IP address of the Secondary DNS server.
Value
Select the rate limit status:
•
Enabled - enables uplink rate limiting feature
•
Disabled - disables uplink rate limiting feature
The default value is Disabled.
Specifies the maximum uplink rate limit over the WAN interface (in bps).
The range is 100,000 to 100,000,000 bps.
WAN advanced configuration
Configuration Guide
89
Advertisement
Table of Contents
