Nortel BSG8ew 1.0 Configuration Manual page 24

24 WAN configuration
3
4
5
6
7
8
Variable definitions
This table describes the variables to configure DSL.
Variable
VPI / VCI
MRU
User Name
Password
Configuring the uplink rate limit
Complete this procedure to enable the uplink rate limit. The rate limit value is based on the uplink
bandwidth of the ADSL service.
Procedure steps
Step
1
2
3
4
NN47928-500 NN47928-500
Your service provider provides you with these values when you set up your
account.
In the MRU field, type the value 1492.
Click Add.
Select the IP Configuration tab.
The PPP Configuration pane appears.
In the User Name field, type the User Name provided by your service provider.
In the Password field, type the Password provided by your service provider.
Click Apply.
Value
The Virtual Path Identifier/Virtual Channel Identifier (VPI/VCI) used by the
DSL modem to make a connection.
The range is 0 to 255.
The default value for VPI is 8 and VCI is 35. These default values do not
appear until you add a configuration.
The Maximum Receivable Unit (MRU) value. MRU specifies the maximum
number of bytes received on a link. The default value is 1492.
The user name for the specified PPP interface, used for authentication.
The user name is provided by your service provider.
The password for the specified PPP interface, used for authentication. The
password is provided by your service provider.
Action
From the BSG navigation pane, select Configuration, WAN, Rate Limit.
The Rate Limit Configuration pane appears.
From the Rate Limit Status list, select Enabled.
In the Uplink Rate Limit field, type the uplink rate limit provided by your ISP.
Click Apply.
End