Table of Contents
Advertisement
84
WAN advanced configuration
Variable
MAC Cloning
MAC Address
IP Address Assignment
WAN IP Address
Subnet Mask
Gateway IP Address
Configurable
Primary DNS
Secondary DNS
PPPoE WAN configuration parameters
The following table describes the parameters for PPPoE configuration located at Configuration,
WAN, Ethernet.
The following table describes the variables and values for configuring PPPoE WAN.
Variable
Interface
Encapsulation Mode
ISP Name
User Name
Password
Host Name
Rate limit configuration parameters (Ethernet)
Certain downstream devices cannot handle the high traffic rate from the BSG. This feature allows
you to limit the rate of traffic sent on the WAN interface. You should limit the uplink speed only if
your WAN bandwidth is less than 100 Mbps and the device in front of the BSG does not support
pause frame.
NN47928-500
NN47928-500
Value
Select the MAC cloning status.
Enable - the BSG uses the configured MAC address as the source of
Ethernet frames instead of the MAC address of the BSG WAN port.
Disable - disables MAC Cloning.
You can enable MAC cloning only if the Encapsulation Mode is Ethernet.
The default value is Disabled.
Type the MAC address, if the MAC cloning is enabled.
Select the IP Address Assignment status.
Select Manual or Dynamic for Ethernet interface.
Type the WAN IP address, if the IP Address Assignment is manual.
Type the subnet mask, if the IP Address Assignment is manual.
Type the gateway IP Address, if the IP Address Assignment is manual.
Type the primary DNS server IP address, if the IP Address Assignment is
manual.
Type the secondary DNS server IP address, if the IP Address Assignment
is manual.
Value
Select an Interface to be configured.
Set the encapsulation mode PPPoE. The WAN interface operates as a
Point-to-Point Protocol (PPP).
Type the name of the Internet Service Provider.
Type the PPPoE user name.
Type the PPPoE password.
Type the host name.
Advertisement
Table of Contents
