Table of Contents
Advertisement
130
IP routing advanced configuration
RIP configuration
RIP manages router information within a self-contained network such as a corporate local area
network (LAN) or an interconnected group of LANs.
RIP configuration navigation
•
RIP basic settings configuration parameters (page 130)
•
Adding a RIP interface (page 131)
•
RIP interface configuration parameters (page 131)
•
RIP neighbor setting configuration parameters (page 132)
•
RIP security settings configuration parameters (page 133)
RIP basic settings configuration parameters
The following section describes the parameters for configuration of RIP basic settings located at
Configuration,
Variable definitions
The following table describes the variables and values for configuring the RIP basic settings.
Variable
Space Periodic Updates
Security Level
Neighbor Filter
Auto-summary
Retransmission Timeout
NN47928-500
NN47928-500
IP Routing, RIP, Basic Settings tab
Value
Specifies the Space Periodic Update status.
Select Enabled to split and send the generated update packets.
The default value is Disabled.
Specifies the security level of the RIP.
Select Minimum to accept RIP 1 packets, even when authentication is in
use.
Select Maximum to ignore RIP 1 packets, even when authentication is in
use.
The default value is Maximum.
Specifies the Neighbor Filter status.
If you select Enabled, RIP packets from a list of router IP addresses are
processed by RIP while packets from other routers are dropped.
If you select Disabled, RIP packets from all routers are processed.
The default value is Disabled.
Select the auto summarization status of RIP as Enabled or Disabled.
The default value is Enabled.
Type the retransmission timeout value to retransmit the request update
packet or an unacknowledged update response packet.
The value ranges between 5 and 10.
The default value is 5 seconds.
.
Advertisement
Table of Contents
