Table of Contents
Advertisement
140
IP routing advanced configuration
RRD configuration
Route Redistribution (RRD) allows different routing protocols to exchange routing information.
RRD configuration navigation
•
RRD basic settings configuration parameters (page 140)
•
RRD RIP settings configuration parameters (page 140)
•
RRD OSPF settings configuration parameters (page 141)
RRD basic settings configuration parameters
The following section describes the configuration parameters for the RRD basic settings located
Configuration, IP Routing, RRD,
Variable definitions
The following table describes the variables and values for configuring the RRD basic settings.
Variable
RRD Status
AS Number
Router ID
RRD RIP settings configuration parameters
The following section describes the parameters for configuration of the RRD RIP settings located
at Configuration, IP Routing, RRD, RIP tab
Variable definitions
The following table describes the variables and values for configuring RRD RIP settings.
Variable
RIP Status
NN47928-500
NN47928-500
Basic Settings
tab
Value
Select the RRD status as Enabled or Disabled.
Select Enabled to enable route redistribution.
Select Disabled to disable route redistribution.
Router redistribution is allowed only after you set the As Number and
Router ID fields to valid values.
Type the Autonomous System (AS) number of the router.
The value ranges from 1 to 65535.
The default value is 0.
Type the router ID. The router ID must be one of the IP addresses of the
IP interfaces configured in the switch.
.
Value
Select the RIP status.
Select Enabled to allow route redistribution in the RIP.
Select Disabled to stop route redistribution in the RIP.
.
at
Advertisement
Table of Contents
