Field Name
PPP Interface
Bundle
Bundle With
Status
Configuring IP information
Complete this procedure to configure IP information.
Procedure steps
Step
Action
1
From the BSG navigation pane, select Configuration, WAN, T1/E1, IP
Configuration.
The IP Configuration pane appears.
2
From the PPP/MP list, select PPP1.
This is the PPP interface you just created.
3
From the IP Address Assignment buttons, select Manual or Dynamic.
4
In the IP Address field, type the IP address of PPP interface.
Set this field if IP Address Assignment is Manual.
5
In the Subnet Mask field, type the subnet mask of the IP address.
Set this field if IP Address Assignment is Manual.
6
In the Peer IP Address field, type the IP address of the peer.
Set this field if IP Address Assignment is Manual.
7
In the Primary DNS field, type the primary DNS server IP address.
Set this field if IP Address Assignment is Manual.
8
In the Secondary DNS field, type the secondary DNS server IP address.
Set this field if IP Address Assignment is Manual.
Description
Read-only field. Specifies the name of the
PPP interface and the serial interface over
which it is layered.
Specifies whether the PPP interface can be
bundled to form a multilink or not. Options are
Yes and No. Select Yes to bundle the PPP
interface to form a multilink. Select No to
unbundle a PPP interface.
•
When a PPP interface is bundled to form
a multilink, you cannot configure the user
name and password for that PPP
interface.
Lists the available Multilink interfaces. Select
the required multilink interface for a specific
PPP interface.
Read-only field to indicate the admin status of
the PPP interface.
WAN configuration
35
Configuration Guide