Table of Contents
Advertisement
3
Initial configuration of the E1/T1 card
Configure basic parameters through command line interface
Follow
101)
Procedure 34
Configuring basic parameters through CLI
Step
1
2
3
4
Power up the system
When you first install and power up the system, the E1/T1 banner appears
on the window. See
displays an example of three enabled spans. After the first power-up, the
banner parameters are empty.
The window displays the following information:
•
•
•
•
The window displays one line for each E1/T1 span.
Media Gateway 1000E PRI Gateway Installation and Commissioning
Copyright © 2007, Nortel Networks
.
•
FRUN is the free run mode
To check the status of the system clock on the specified superloop
and shelf, enter the command:
SSCK 1 s
Procedure 34 "Configuring basic parameters through CLI" (page
to configure the basic parameters.
Action
Connect to the CLI through RS-232. Make sure the CLI screen is
active.
Power up the system.
Enter the LAN settings. For detailed information, see
LAN parameters" (page
Verify the network connections. For detailed information, see
network connections" (page
Figure 17 "General status display" (page 103)
logo
customer-defined card name
status of the E1/T1 spans
IP address
Nortel Communication Server 1000
NN43041-311 01.01 Standard
Release 5.0 30 May 2007
Initial configuration of the E1/T1 card 101
—End—
103).
104).
—End—
"Configure
"Verify
which
Advertisement
Table of Contents
