Table of Contents
Advertisement
H.248 User's Manual
5
Getting Started
The MG 3200 is supplied with application software already resident in its flash memory
(with factory default parameters). The MG 3200 is also supplied with an Embedded
(integrally stored) Web Server.
'Assigning the MG 3200 IP Address' below describes how to assign an IP address to the
MG 3200.
''Restoring Networking Parameters to their Initial State'' on page
restore the network parameters to their initial state.
For detailed information on how to fully configure the gateway refer to the ''Embedded Web
Server'' on page 141.
5.1
Assigning the MG 3200 IP Address
To assign an IP address to the MG 3200 use one of the following methods:
HTTP using a Web browser (refer to ''Assigning an IP Address Using HTTP'' on page
47).
BootP (refer to ''Assigning an IP Address Using BootP'' on page 48).
DHCP (refer to (refer to ''Using BootP/DHCP' on page 53').
The default networking parameters are show in the table below.
MG 3200 Version
Single module (up to 8 Trunks)
Double module (up to 16
Trunks)
Default subnet mask is 255.255.0.0, default gateway IP address is 0.0.0.0
5.1.1
Assigning an IP Address Using HTTP
To assign an IP address using HTTP, take these 8 steps:
1.
Connect your computer to the MG 3200. Either connect the network interface on your
computer to a port on a network hub / switch (using an RJ-45 Ethernet cable), or use
an Ethernet cross-over cable to directly connect the network interface on your
computer to the RJ-45 jack on the MG 3200.
2.
Change your PC's IP address and subnet mask to correspond with the MG 3200
factory default IP address and subnet mask, shown in the table above. For details on
changing the IP address and subnet mask of your PC, refer to Windows™ Online Help
(Start>Help).
Version SN09
Table 5-1: TP-1610 Default Networking Parameters
Default Value
10.1.10.10 (Trunks 1-8) and 10.1.10.11 (Trunks 9-16)
10.1.10.10
47
5. Getting Started
49
describes how to
October 2006
Advertisement
Table of Contents
Troubleshooting
