Nortel BSG8ew 1.0 Configuration Manual page 53

Variable definitions
The following table describes the variables and values for configuring FXO information.
Variable
FXO Channel
Channel Enable
Channel Number
Password
Forward Number
Emergency Number
Ring Count
On Hook Detection Time
End
Value
Select the required FXO channel.
Select this check box to enable the administrative status of the
FXO channel.
The channel is available for use only when it is enabled.
Type the FXO channel number. This is the number which
identifies the FXO line for an incoming call.
Type the password to access the FXO Channel.
Type the forward number. This number is used when an
incoming call on the FXO channel requires forwarding.
Type the emergency number of the contact.
Type the ring count. This is the maximum number of rings
within which FXO must get an answer from the remote
number.
The minimum value is 1 and maximum value is 6.
The default value is 2. This default appears after you configure
the channel number.
Type the on-hook detection time.
The value ranges from 100 to10000 milliseconds.
The default value is 2000 milliseconds. This default appears
after you configure the channel number.
SIP configuration 53
Configuration Guide