Table of Contents
Advertisement
3
In the VLAN Name field, type the VLAN name.
4
In the Member Ports field, type the numbers and/or ranges of member ports.
5
In the Untagged Ports field, type the numbers and/or ranges of untagged ports.
6
Click Add.
7
From the BSG navigation pane, select Configuration, VLAN, Setup, Port
Setting tab.
The VLAN Port Settings pane appears.
8
Select the port setting that you want to modify.
This is the list of member ports you added to the new VLAN in step 4.
9
In the PVID field, type the port VLAN ID.
Use the same value you entered for VLAN ID in step 2.
10
Click Apply.
Variable definitions
The following table describes the variables and values for creating a VLAN.
Variable
VLAN ID
VLAN Name
Member Ports
Untagged Ports
PVID
Configuring the virtual interface
Complete this procedure to configure the virtual interface. You must configure a virtual interface
if hosts on the new VLAN need to communicate with other hosts on other VLANs or on the WAN.
Procedure steps
Step
Action
1
From the BSG navigation pane, select Configuration, LAN, Virtual Interfaces.
The IP Address Configuration pane appears.
End
Value
Type a unique VLAN ID that you want to configure as a static VLAN.
Type the VLAN name.
Type the member port number list for a VLAN.
Member ports represent the set of ports permanently assigned to the
VLAN egress list. Frames that belong to the specified VLAN are forwarded
on the ports in the egress list.
Enter a comma separated list of ports or port ranges. For example, 1-6, 9,
11.
Type the untagged port number list for a VLAN.
Enter a comma separated list of ports or port ranges. For example, 1-6, 9,
11.
The Untagged Ports list must be a subset of the Member Ports.
Type the port VLAN ID.
VLAN configuration
39
Configuration Guide
Advertisement
Table of Contents
