Table of Contents
Advertisement
Prerequisites to adding a RIP neighbor setting
•
To configure Neighbor IP address, you must enable Neighbor Filter (see
configuration parameters (page
Variable definitions
The following table describes the variable and value for adding a RIP neighbor setting.
Variable
IP Address
RIP security settings configuration parameters
The following section describes the parameters for configuration of RIP interfaces located at
Configuration,
IP Routing, RIP, Security Settings tab
Variable definitions
The following table describes the variables and values for configuring the type of authentication to
use on a specific interface.
Variable
Select
IP Address
Authentication Type
Authentication Key
130)).
Value
Type the IP address of the neighbor router to which the unicast update is
sent.
Value
Select the RIP interface you want to configure.
Displays the IP address of the RIP interface.
The authentication type. Select one of the following options:
•
No Authentication - disables authentication.
•
Simple Password - simple password based authentication.
•
MD5 - message digest 5 based authentication
The default value is No Authentication.
Type the key used for authentication, if the authentication type is not No
Authentication.
When you modify the Authentication Type (to a type that requires a key),
make sure you also modify the Authentication Key.
The authentication key is an octet string with the string length ranging
between 0 and 16 alphanumeric characters.
The Authentication Key (password) does not appear in the UI after you
configure a RIP security setting.
IP routing advanced configuration
RIP basic settings
.
Configuration Guide
133
Advertisement
Table of Contents
