Vlan Port Settings Configuration Parameters - Nortel BSG8ew 1.0 Configuration Manual

112 VLAN advanced configuration
Variable definitions
The following table describes the variables and values for configuring the basic VLAN settings.
Variable
Dynamic VLAN Learning
Dynamic Multicast Learning
Protocol Based VLAN

VLAN port settings configuration parameters

You can associate a VLAN ID to a port for port-based VLAN classification.
The following section describes the parameters for configuration of the VLAN port settings
located at Configuration,
Variable definitions
The following table describes the variables and values for configuring the VLAN port settings.
Variable
Port
Port Name
Port and Protocol Based VLAN Specifies the port and protocol-based VLAN status.
PVID
Acceptable Frame Types
NN47928-500 NN47928-500
Value
Specifies the Dynamic VLAN learning status.
Select Enable to enable the global GARP VLAN Registration Protocol
(GVRP) status.
Select Disable to disable the global GVRP status.
If the status is disabled, then the GVRP is disabled for the current port.
The default value is Enable.
Specifies the Dynamic Multicast learning status.
If the status is disabled, then the GMRP is disabled for the current port.
The default value is Enable.
Specifies the protocol-based learning status.
The default value is Enable.
VLAN setup, Port Settings tab
Value
Displays the port ID for which you want to configure the VLAN port
settings.
Type the name of the port.
Select Enable – the protocol grouping in VLAN is enabled.
Select Disable – the protocol grouping in VLAN is disabled.
The VLAN classification on a port will be port and protocol-based as long
as the port and protocol-based classification is enabled globally for the
device.
The default value is Enable.
Type the port VLAN ID.
Specifies the acceptable frame types as Tagged or All.
Select Tagged – the switch discards untagged and priority- tagged frames
received on the port and processes only the VLAN tagged frames.
Select All – the switch accepts all frames, including untagged frames or
priority-tagged frames received on the port.
The default value is All.
.