Table of Contents
Advertisement
Variable definitions
The following table describes the variables and values for configuring the uplink rate limit.
Variable
Rate Limit Status
Uplink Rate Limit
Renewing or releasing the WAN lease
Complete this procedure to renew or release the lease.
Prerequisites
•
You can renew or release the WAN lease only if the IP Address Assignment is Dynamic.
Procedure steps
Step
1
2
3
4
Variable definitions
The following table describes the variables and values for renewing and releasing the lease.
Variable
Select
Value
Select the rate limit status:
•
Enabled - enables uplink rate limiting feature
•
Disabled - disables uplink rate limiting feature
The default value is Disabled.
Specifies the maximum uplink rate limit over the WAN interface (in bps).
The range is 100,000 to 100,000,000 bps.
Action
From the BSG navigation pane, select Configuration, WAN, Ethernet.
The WAN Configuration panel appears.
In the Select field, select the WAN configuration that you want to modify.
Select the Renew option button if you want to renew the lease term.
OR
Select the Release option button if you want to release the lease.
Click Apply.
Value
Select the interface entry you want to configure.
WAN advanced configuration
End
85
Configuration Guide
Advertisement
Table of Contents
