Ospf Link State Database Display Parameters - Nortel BSG8ew 1.0 Configuration Manual

Gateway
Type
Area ID
Cost
Type 2 Cost
Interface

OSPF link state database display parameters

The following section describes the display parameters for the OSPF link state database located
Configuration, IP Routing, OSPF, Link State Database tab
Variable definitions
The following table describes the variables and values displayed on the OSPF Link State Database
panel.
Variable
Area ID
Type
Link ID
ADV Router
Age(seconds)
Sequence Number
Checksum
Link Count
Displays the gateway of the OSPF router.
Displays the OSPF router type.
Displays the area ID of the OSPF router
Displays the cost of the OSPF router.
Displays the type 2 cost of the OSPF router.
Displays the interface ID of the OSPF interface.
Value
Displays the Area ID associated with the OSPF address range.
Displays the area type.
Displays the Link Identifier. The value is in the form of an IP address.
Displays all of the router Link State Advertisements (LSAs). If IP address
is not included, then the information displayed describes the local router.
Displays the route age value.
Displays the OSPF sequence number. The OSPF sequence number is a
32 bit signed integer.
The sequence number starts with the value '80000001'h or '-7FFFFFFF'h.
Displays the checksum value.
Displays the link count value.
IP routing advanced configuration
.
Configuration Guide
139
at