Table of Contents
Advertisement
QoS advanced configuration
Quality of Service (QoS) is an architecture for providing different levels of service for network
traffic. This section describes the advanced configuration for QoS for Business Service Gateway
(BSG).
Prerequisites for QoS advanced configuration
•
You must have SYSTEM - READ WRITE permission to access QoS configuration.
QoS advanced configuration navigation
•
QoS basic settings configuration parameters (page 159)
•
Policy map settings configuration parameters (page 159)
•
Class maps configuration parameters (page 160)
•
Marking configuration parameters (page 161)
•
Port based QoS configuration parameters (page 161)
•
QoS queue settings configuration parameters (page 162)
QoS basic settings configuration parameters
The following section describes the parameters for configuration of the QoS basic settings located
at Configuration,
Variable definitions
The following table describes the variable and value for configuring QoS basic settings.
Variable
QoS Status
Policy map settings configuration parameters
The following section describes the parameters for configuration of the QoS policy map settings
located at Configuration,
QoS, Basic Settings tab
Value
Select the module status of QoS.
If you select Enable, the DiffServ module programs the hardware and
starts the protocol operation.
If you select Disable, the DiffServ module stops the protocol operation by
deleting the hardware configuration.
The default value is Enable.
QoS, Policy Map tab
.
.
159
Configuration Guide
Advertisement
Table of Contents
