Nortel BSG8ew 1.0 Configuration Manual page 108

108 LAN advanced configuration
Variable definitions
The following table describes the variables and variables for configuring wireless multimedia.
Variable
WMM Status
Acknowledge Policy
AC0 (Best Effort)
AC1 (Background)
AC2 (Video)
AC3 (Video)
Basic Service Set Parameters
Log Contention Width
Minimum
Log Contention Width
Maximum
AIFSN
TXOP Limit
Admission Control
Access Point Parameters
Log Contention Width
Minimum
Log Contention Width
Maximum
NN47928-500 NN47928-500
Value
Specifies the Wireless Multimedia (WMM) status.
Select Disabled to disable Quality of Service (QoS).
Select Supported or Required to enable QoS.
The default is Disabled.
Select the status of AC0 as either Acknowledge or No Acknowledge.
The default value is Acknowledge.
Select the status of AC1 as either Acknowledge or No Acknowledge.
The default value is Acknowledge.
Select the status of AC2 as either Acknowledge or No Acknowledge.
The default value is Acknowledge.
Select the status of AC3 as either Acknowledge or No Acknowledge.
The default value is Acknowledge.
The minimum contention width of the AP in the radio.
The range is 1 to 15.
The default values for AC0 through AC3 are 4, 4, 3, and 2.
The maximum contention width of the AP in the radio.
The range is 1 to 15.
The default values for AC0 through AC3 are 10, 10, 4, and 3.
The arbitrary inter frame sequence (AIFS).
The range is 1 to 15.
The default values for AC0 through AC3 are 3, 7, 2, and 2.
The transmission opportunity of the AP in the radio.
The range is 0 to 65535.
The default values for AC0 through AC3 are 0, 0, 94, and 47.
The status of admission of WMM parameters.
Options:
Enabled
Disabled.
The default value for AC0 through AC3 is Disabled.
The minimum contention width of the AP in the radio.
The range is 1 to 15.
The default values for AC0 through AC3 are 4, 4, 3, and 2.
The maximum contention width of the AP in the radio.
The range is 1 to 15.
The default values for AC0 through AC3 are 6, 10, 4, and 3.