Free Of Charge Phone Call; Sms Text Message - Eldes ESIM384 Installation Manual

12.1. free of Charge Phone Call

to arm, disarm the system and turn OFF the alarm, dial the system's phone number from any of 10 available user phone numbers
(see 8. USEr PHonE nUMBErS for user phone number management). the phone call is free charge as the system rejects it
and carries out arming/disarming procedure afterwards. When arming – the system rejects the phone call after 2 rings, when
disarming – the system rejects the phone call immediately. If there is more than one listed user dialling to the system at the
same time, the sys tem will accept the incoming call from the user who was the first to dial while other user (-s) will be ignored.
When system's phone number is dialled for arming, the system will proceed as follows:
• non-partitioned system:
• If ready (no violated zone/tamper), the system will arm.
• If unready (violated zone/tamper is present), the system will not arm and provide a list of violated zones/tampers by SMS text
message to user phone number. In such case the user must restore all violated zones and tampers before arming the system.
Alternatively, the violated zones can be bypassed (see 14.7. Bypassing and activating Zones), disabled (see 14.9. Disabling
and Enabling Zones) or a Force attribute enabled (resulting in partial arm; see 14.6. Zone attributes), while the tampers can
be disabled (see 16. taMPErS).
• Partitioned system:
• If all partitions are disarmed ready, the system will arm them.
• If one or more partitions are disarmed unready (violated zone/tamper is present), the system will arm the ready partition (-s) and
skip the unready one (-s). the system will then send an SMS text message, containing a list of violated zones/tampers, to user
phone number that the system arming was initiated from.
• If a combination of armed and disarmed ready partitions is present, the system will arm the disarmed ready partitions and skip
the armed ones.
When a user phone number is assigned to multiple partitions, the user will be able arm/disarm the corresponding system partitions by
dialling the system's phone number. For example, if User 1 is assigned to Partition 1, 2 and 3, the user will be able to arm/disarm Partition 1,
2 and 3 by a single phone call to the system from User 1 phone number. For more details on how to set user phone number partition, please
refer to 23.2. User Phone number Partition.
Call
User
By default, all listed user phone numbers are granted with permission to arm and disarm the system by free of charge phone call and SMS
text message. to disable/enable arming or disarming for certain listed user phone numbers, please refer to the following configuration
method.
Manage arming and
disarming for listed
user phone numbers

12.2. SMS text Message

to arm the system by SMS text message, send the following text to the system's phone number from any of 10 available user
phone numbers (see 8. USEr PHonE nUMBErS for user phone number management).
SMS
arm the system
44 44 EN
32
eSIM384
ElDES
Config-
this operation may be carried out from the PC using the ELDES Configuration software.
uration
software
SMS text message content:
ssss_ARMp or ssss_ARMp,p,p,p
Value: ssss – 4-digit SMS password; p – partition number, range – [1... 4].
Example: 1111_ARM1
User
33
SMS
eSIM384
ESIM384 Installation and Configuration Manual v1.1