Table of Contents
Advertisement
3.1
Removal
Please note the following information when removing the BOP20 from the Control Unit:
1. Simultaneously press the latching cams on the BOP20.
2. Always withdraw the BOP20 straight out (without skewing it). Never withdraw the BOP20
by pulling it at its lower edge, as this could damage the interface at the rear.
Figure 3-1
Basic Operator Panel 20 (BOP20)
Operating Instructions, 11/2017, A5E00809375A
Incorrect removal of the BOP20 from a CU320-2 DP (example)
Installation
3.1 Removal
17
Advertisement
Table of Contents
