Data Transmission Options; Transfer; Overview; Starting Manual Transfer - Siemens SIMATIC HMI KP300 Basic mono PN Operating Instructions Manual

6.3

Data transmission options

Overview

The following table shows the options for data transfer between the HMI device and
configuration PC.
Type
Backup/restore,
Operating system update
Project transfers
Updating the operating system
with "Reset to factory settings"
1
6.4

Transfer

6.4.1 Overview
Transfer the executable project from the configuration PC to the HMI device.
You can start the "Transfer" mode manually or automatically on the HMI device.
Transferred data is written directly to internal flash memory of the HMI device. Parameterize
a corresponding data channel before you start the transfer.
6.4.2

Starting manual transfer

Introduction
You can manually switch the HMI device to "Transfer" mode as follows:
● At runtime, using a configured operating element.
● In the Loader of the HMI device.
Requirements
● The project is open in WinCC flexible or WinCC.
● The project is compiled.
● The HMI device is connected to a configuring PC.
● The data channel is configured on the HMI device.
● The HMI device is in "Transfer" mode.
Basic Panels
Operating Instructions, 04/2012, A5E02421799-03
Applies for operations with PC/PPI cable 6ES7 901-3CB30-0XA0 or USB/PPI cable
6ES7 901-3DB30-0XA0.
Data channel
Serial
1
MPI/PROFIBUS DP
PROFINET
Serial
1
MPI/PROFIBUS DP
PROFINET
Commissioning a project
6.3 Data transmission options
Basic Panels DP Basic Panels PN
Yes
Yes
-
Yes
-
-
-
-
Yes
-
-
Yes
91