Qos Carl - HPE FlexNetwork HSR6800 series Command Reference Manual

•
The CIR is 200 kbps.
•
The CBS is 51200 bytes.
<Sysname> system-view
[Sysname] user-profile user
[Sysname-user-profile-user] qos car outbound any cir 200 cbs 51200

qos carl

Use qos carl to create or modify a CAR list.
Use undo qos carl to delete a CAR list.
Syntax
qos carl carl-index { dscp dscp-list | mac mac-address | mpls-exp mpls-exp-value | precedence
precedence-value | { destination-ip-address | source-ip-address } { range start-ip-address to
end-ip-address | subnet ip-address mask-length } [ per-address [ shared-bandwidth ] ] }
undo qos carl carl-index
Default
No CAR list is configured.
Views
System view
Predefined user roles
network-admin
Parameters
carl-index: Specifies a CAR list by its number in the range of 1 to 199.
dscp dscp-list: Specifies a list of DSCP values. A DSCP value can be a number from 0 to 63 or any
of the following keywords af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, cs1,
cs2, cs3, cs4, cs5, cs6, cs7, default, or ef. You can configure up to eight DSCP values in one
command line. If the same DSCP value is specified multiple times, the system considers the values
to be one value. If a packet matches one of the defined DSCP values, it matches the if-match
clause.
mac mac-address: Specifies a MAC address in hexadecimal format.
mpls-exp mpls-exp-value: Specifies an MPLS EXP value in the range of 0 to 7. You can configure up
to eight MPLS EXP values in one command line. If the same MPLS EXP value is specified multiple
times, the system considers the values to be one value. If a packet matches one of the defined MPLS
EXP values, it matches the if-match clause.
precedence precedence: Specifies a precedence value in the range of 0 to 7. You can configure up
to eight IP precedence values in one command line. If the same IP precedence value is specified
multiple times, the system considers the values to be one value. If a packet matches one of the
defined IP precedence values, it matches the if-match clause.
destination-ip-address: Configures a destination IP address-based CAR list.
source-ip-address: Configures a source IP address-based CAR list.
range start-ip-address to end-ip-address: Specifies an IP address range by the start address and
end address. The value for end-ip-address must be greater than the value for start-ip-address. The
maximum number of IP addresses that an IP address range can accommodate is 1024.
subnet ip-address mask-length: Specifies a subnet by the IP subnet address and IP subnet address
mask length.
77