Display Qos Policy L2Vpn-Pw - HPE FlexNetwork HSR6800 series Command Reference Manual

display qos policy l2vpn-pw

Use display qos policy l2vpn-pw to display the QoS policies applied to PWs.
Syntax
display qos policy l2vpn-pw [ peer ip-address pw-id pw-id ] [ outbound ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
peer ip-address pw-id pw-id: Specifies a PW by its peer PE LSR ID and its PW ID. The ip-address
argument represents the LSR ID of the peer PE of the PW. The value range for the pw-id argument is
1 to 4294967295. If you do not specify a PW, this command displays the QoS policies applied to all
PWs.
outbound: Displays the QoS policies applied to the outgoing traffic of PWs.
Usage guidelines
The specified LSR ID and PW ID uniquely identify the PW.
If you do not specify a direction, this command displays the QoS policies applied to outgoing traffic of
PWs.
Examples
# Display the QoS policy applied to the outgoing traffic of PW 1 with peer PE IP address 1.1.1.1.
<Sysname> display qos policy l2vpn-pw peer 1.1.1.1 pw-id 1 outbound
L2VPN-PW: peer 1.1.1.1, pw-id 1
Direction: Outbound
Policy: 1
Classifier: 1
Matched : 0 (Packets) 0 (Bytes)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped
Operator: AND
Rule(s) :
If-match acl 2000
Behavior: 1
Marking:
Remark dscp 3
Committed Access Rate:
CIR 112 (kbps), CBS 5120 (Bytes), EBS 512 (Bytes)
Green action
Yellow action : pass
Red action
: 0/0 (pps/bps)
: pass
: discard
62