Wfq Commands; Display Qos Queue Wfq - HPE FlexNetwork HSR6800 series Command Reference Manual

Default
The number of bytes forwarded from a queue during a cycle is 1500 bytes.
Views
System view
Predefined user roles
network-admin
Parameters
cql-index: Specifies a CQ list by its number in the range of 1 to 16.
queue-id: Specifies a custom queue by its ID in the range of 1 to 16.
byte-count: Specifies the number of bytes forwarded from a queue during a cycle of queue
scheduling. The value range for the byte-count argument is 1 to 16777215 bytes.
Examples
# In CQ list 5, set the byte count to 1400 for queue 2.
<Sysname> system-view
[Sysname] qos cql 5 queue 2 serving 1400

WFQ commands

display qos queue wfq

Use display qos queue wfq to display the WFQ information for interfaces or PWs.
Syntax
display qos queue wfq { interface [ interface-type interface-number ] | l2vpn-pw [ peer ip-address
pw-id pw-id ] }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays the WFQ information for all interfaces.
peer ip-address pw-id pw-id: Specifies a PW by its peer PE LSR ID and its PW ID. The ip-address
argument represents the LSR ID of the peer PE of the PW. The value range for the pw-id argument is
1 to 4294967295. If you do not specify a PW, this command displays the WFQ information for all
PWs.
Examples
# Display the WFQ information for GigabitEthernet 2/1/1.
<Sysname> display qos queue wfq interface gigabitethernet 2/1/1
Interface: GigabitEthernet2/1/1
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - Weighted Fair queuing: Size/Length/Discards 0/64/0
102