Qos Wfq - HPE FlexNetwork HSR6800 series Command Reference Manual

Weight: IP Precedence
Queues: Active/Max active/Total 0/0/128
# Display the WFQ information for all PWs.
<Sysname> display qos queue wfq l2vpn-pw
L2VPN-PW: peer 1.1.1.1, pw-id 1
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - Weighted Fair queuing: Size/Length/Discards 0/64/0
Weight: IP Precedence
Queues: Active/Max active/Total 0/0/128
Table 33 Command output
Field
Interface
L2VPN-PW
Size
Length
Discards
Weight
Active
Max active
Total

qos wfq

Use qos wfq to apply WFQ to an interface or PW. You can also use this command to modify WFQ
parameters.
Use undo qos wfq to restore the default.
Syntax
qos wfq [ dscp | precedence ] [ queue-number total-queue-number | queue-length
max-queue-length ] *
undo qos wfq
Default
An interface or PW uses FIFO queuing.
Views
Cross-connect PW view
VSI LDP PW view
VSI static PW view
Interface view
Description
Interface name, including the interface type and interface
number.
A PW is uniquely identified by a combination of the peer PE IP
address and PW ID.
Total number of bytes of packets in all queues.
Number of packets allowed in each queue.
Number of dropped packets.
Weight type:
•
IP Precedence.
•
DSCP.
Number of active WFQ queues.
Maximum number of active WFQ queues that was reached.
Total number of configured WFQ queues.
103