Related Commands; Troubleshooting Qos And Acl - HPE FlexNetwork 10500 SERIES Troubleshooting Manual

c. If transceiver modules and fibers are used, execute the display transceiver
diagnosis command. Make sure the transmit and receive power has not exceeded the
power specifications of the fiber module.
d. Remove hardware problems that might cause recurring PEX split events:
e. Execute the display version command to identify the uptime of devices or interface
modules that have PEX links.
f. Compare the uptime of devices or interface modules to determine whether a device or
interface module had rebooted before the PEX split.
g. If the PEX split is caused by a reboot, use the methods described in
hardware" to resolve the problem.
2. If the problem persists, contact Hewlett Packard Enterprise Support.

Related commands

This section lists the commands that you might use for troubleshooting IRF:
Command
display boot-loader pex
display diagnostic-information
display interface
display interface brief
display interface pex
display irf
display irf configuration
display irf topology
display mad verbose
display max-ecmp-num
display pex-port
display system-working-mode
display transceiver diagnosis
display trapbuffer
display version
display vlan

Troubleshooting QoS and ACL

This section provides troubleshooting information for common QoS and ACL problems.
Description
Displays PEX startup software images.
Displays or saves the operating statistics for multiple feature
modules.
Displays interface information.
Displays brief interface information.
Displays PEX physical interface information.
Displays IRF fabric information, including the member ID, role,
priority, bridge MAC address, and description of each IRF
member.
Displays the IRF configuration on each member chassis.
Displays the IRF topology.
Displays detailed MAD configuration.
Displays the maximum number of ECMP routes.
Displays information about PEX ports.
Displays system operating mode information.
Displays the present measured values of the digital diagnosis
parameters for transceiver modules.
Displays trap data in the trap buffer.
Displays system version information.
Displays VLAN information.
72
"Troubleshooting