Gts Percent - HPE FlexNetwork HSR6800 series Command Reference Manual

Predefined user roles
network-admin
Parameters
cir committed-information-rate: Sets the CIR in kbps, which specifies the average traffic rate.
cbs committed-burst-size: Sets the CBS in bytes, which specifies the size of bursty traffic when the
actual average rate is not greater than CIR.
ebs excess-burst-size: Sets the EBS in bytes.
pir peak-information-rate: Sets the PIR in kbps. The PIR cannot be smaller than the CIR.
queue-length queue-length: Sets the maximum queue length. The default is 50.
Usage guidelines
To use two rates for traffic shaping, configure the gts command with the pir peak-information-rate
option. To use one rate for traffic shaping, configure the gts command without the pir
peak-information-rate option.
A QoS policy that uses a behavior configured with GTS can be applied only to the outbound direction
of an interface.
A QoS policy that uses a behavior configured with GTS overwrites the qos gts command on the
interface, if both are configured.
If you execute the gts command multiple times in the same traffic behavior, the most recent
configuration takes effect.
Examples
# Configure a GTS action in absolute value in traffic behavior database. The GTS parameters are as
follows: CIR is 200 kbps, CBS is 51200 bytes, EBS is 0, and the maximum queue length is 100.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] gts cir 200 cbs 51200 ebs 0 queue-length 100
Related commands

gts percent

gts percent
Use gts percent to configure a GTS action in percentage in a traffic behavior.
Use undo gts to restore the default.
Syntax
gts percent cir cir-percent [ cbs cbs-time [ ebs ebs-time ] ] [ queue-length queue-length ]
undo gts
Default
No GTS action is configured.
Views
Traffic behavior view
Predefined user roles
network-admin
48