Remark Dot1P - HPE FlexNetwork HSR6800 series Command Reference Manual

Parameters
cir cir-percent: Specifies the CIR in percentage, in the range of 1 to 100. The actual CIR value is
cir-percent × interface bandwidth.
cbs cbs-time: Specifies the CBS in milliseconds. The default cbs-time is 500 milliseconds. The
actual CBS value is cbs-time × the actual CIR value.
ebs ebs-time: Specifies the EBS in milliseconds. The default ebs-time is 0 milliseconds. The actual
EBS value is ebs-time × the actual CIR value.
queue-length queue-length: Specifies the maximum queue length. The default is 50.
Usage guidelines
A QoS policy that uses a behavior configured with percentage-based GTS can be applied only to the
outbound direction of an interface.
A QoS policy that uses a behavior configured with percentage-based GTS overwrites the qos gts
command on the interface, if both configured.
If you execute the gts percent command multiple times in the same traffic behavior, the most recent
configuration takes effect.
Examples
# Configure a GTS action in percentage in traffic behavior database. The GTS parameters are as
follows: CIR is 50 and CBS is 200 ms.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] gts percent cir 50 cbs 200
Related commands
gts

remark dot1p

Use remark dot1p to configure an 802.1p priority marking action in a traffic behavior.
Use undo remark dot1p to restore the default.
Syntax
remark dot1p dot1p-value
undo remark dot1p
Default
No 802.1p priority marking action is configured.
Views
Traffic behavior view
Predefined user roles
network-admin
Parameters
dot1p-value: Specifies the 802.1p priority to be marked for packets, in the range of 0 to 7.
Examples
# Configure traffic behavior database to mark matching traffic with 802.1p 2.
<Sysname> system-view
[Sysname] traffic behavior database
49