Pq Commands; Display Qos Queue Pq Interface - HPE FlexNetwork HSR6800 series Command Reference Manual

Usage guidelines
For FIFO queuing to take effect on a subinterface, you must configure the rate limit on the
subinterface.
Examples
# Set the FIFO queue length to 100 on GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] qos fifo queue-length 100
Related commands
display qos queue fifo interface

PQ commands

display qos queue pq interface

Use display qos queue pq interface to display the PQ information for interfaces.
Syntax
display qos queue pq interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays the PQ information for all interfaces.
Usage guidelines
If you specify a VT interface, this command displays the PQ information for all VA interfaces of the VT
interface. A VT interface itself does not have QoS information.
Examples
# Display the PQ information for GigabitEthernet 2/1/1.
<Sysname> display qos queue pq interface gigabitethernet 2/1/1
Interface: GigabitEthernet2/1/1
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - Priority queuing: PQL 1 Size/Length/Discards
Top: 0/20/0
Table 29 Command output
Field
Priority queuing:
PQL 1
Size
Middle: 0/40/0
Description
PQL 1 indicates the PQ list in use.
Total number of bytes of packets in all queues.
Normal: 0/60/0
88
Bottom: 0/80/0