Reset Qos Policy Advpn - HPE FlexNetwork HSR6800 series Command Reference Manual

Default
No QoS policies exist.
Views
System view
Predefined user roles
network-admin
Parameters
policy-name: Specifies a name for the QoS policy, a case-sensitive string of 1 to 31 characters.
Usage guidelines
To delete a QoS policy that has been applied to an object, you must first remove the QoS policy from
the object.
Examples
# Create a QoS policy named user1.
<Sysname> system-view
[Sysname] qos policy user1
[Sysname-qospolicy-user1]
Related commands
classifier behavior
qos apply policy

reset qos policy advpn

Use reset qos policy advpn to clear the statistics for QoS policies applied to hub-spoke tunnels on
a tunnel interface.
Syntax
reset qos policy advpn tunnel number [ ipv4-address | ipv6-address ] [ outbound ]
Views
User view
Predefined user roles
network-admin
Parameters
number: Specifies a tunnel interface by its number in the range of 0 to 20479.
ipv4-address: Specifies the spoke's private IPv4 address of a hub-spoke tunnel.
Ipv6-address: Specifies the spoke's private IPv6 address of a hub-spoke tunnel.
outbound: Clears the statistics for the QoS policy applied to outgoing traffic.
Usage guidelines
If you do not specify a spoke's private IP address of a hub-spoke tunnel, this command clears the
QoS policy statistics for all hub-spoke tunnels on a tunnel interface. For information about hub-spoke
tunnels, see ADVPN in Layer 3—IP Services Configuration Guide.
If you do not specify a direction, this command clears QoS policy statistics for both incoming traffic
and outgoing traffic.
70