Display Traffic Behavior - HPE FlexNetwork HSR6800 series Command Reference Manual

•
remark-mpls-exp-pass new-exp: Sets the EXP field value of the MPLS packet to new-exp and
permits the packet to pass through. The new-exp argument is in the range of 0 to 7.
•
remark-prec-pass new-precedence: Sets the IP precedence of the packet to new-precedence
and permits the packet to pass through. The new-precedence argument is in the range of 0 to 7.
Usage guidelines
To use two rates for traffic policing, configure the car percent command with the pir percent
pir-percent option. To use one rate for traffic policing, configure the car percent command without
the pir percent pir-percent option.
A QoS policy that uses a traffic behavior configured with percentage-based CAR can be applied in
the inbound or outbound direction of an interface.
If you execute the car percent command multiple times in the same traffic behavior, the most recent
configuration takes effect.
A QoS policy that uses a behavior configured with percentage-based CAR can be applied only to
interfaces.
The actual CIR value is cir-percent × bandwidth. The actual PIR value is pir-percent × bandwidth. In
the policy nesting case, the bandwidth used for the CIR and PIR calculations is determined by using
the following rules:
•
The top policy uses the interface bandwidth.
•
A child policy uses the CIR value in GTS configured in the behavior of the child policy.
•
If the CIR value is not available in the behavior, the child policy uses the CIR value in GTS
configured in the behavior of the higher-level policy.
•
If the CIR value is not available in the behavior of the higher-level policy, the child policy uses
the interface bandwidth.
Examples
# Configure a CAR action in percentage in traffic behavior database. The CAR parameters are as
follows: CIR is 20% and CBS is 100 ms.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] car cir percent 20 cbs 100

display traffic behavior

Use display traffic behavior to display traffic behaviors.
Syntax
In standalone mode:
display traffic behavior { system-defined | user-defined } [ behavior-name ] [ slot slot-number ]
In IRF mode:
display traffic behavior { system-defined | user-defined } [ behavior-name ] [ chassis
chassis-number slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
44