Rtpq Commands; Display Qos Queue Rtpq Interface - HPE FlexNetwork HSR6800 series Command Reference Manual

Predefined user roles
network-admin
Parameters
dscp: Specifies a DSCP weight.
precedence: Specifies an IP precedence weight.
queue-length max-queue-length: Specifies the maximum number of packets a queue can hold. The
value range for the max-queue-length argument is 1 to 1024, and the default is 64.
queue-number total-queue-number: Specifies the total number of queues, which can be 16, 32, 64,
128, 256, 512, 1024, 2048, or 4096. The default is 256.
Usage guidelines
If you do not specify a weight type, the default weight type is IP precedence.
You must configure the rate limit for the WFQ feature to take effect on the following interfaces:
•
Tunnel interfaces.
•
Subinterfaces.
•
Layer 3 aggregate interfaces.
•
HDLC link bundle interfaces.
•
VT interfaces configured with PPPoE.
Examples
# Apply WFQ to GigabitEthernet 2/1/1, and set the maximum queue length to 100 and the total
number of queues to 512.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] qos wfq queue-length 100 queue-number 512
Related commands
display qos queue wfq interface

RTPQ commands

display qos queue rtpq interface

Use display qos queue rtpq interface to display the RTPQ information for interfaces.
Syntax
display qos queue rtpq interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays the RTPQ information for all interfaces.
104