HPE FlexNetwork HSR6800 series Command Reference Manual page 14

Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. VLAN
interfaces are not supported. If you do not specify an interface, this command displays ACL
application information for packet filtering on all interfaces except VLAN interfaces.
inbound: Specifies the inbound direction.
outbound: Specifies the outbound direction.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
displays ACL application information for packet filtering for the active MPU. (In standalone mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number
argument represents the slot number of the card. If you do not specify a card, this command displays
ACL application information for packet filtering for the global active MPU. (In IRF mode.)
Usage guidelines
This command displays ACL application information for interface-based packet filtering in both
directions if neither the inbound keyword nor the outbound keyword is specified.
Examples
# Display ACL application information for inbound packet filtering on interface GigabitEthernet 2/1/1.
<Sysname> display packet-filter interface gigabitethernet 2/1/1 inbound
Interface: GigabitEthernet2/1/1
Inbound policy:
IPv4 ACL 2001
IPv6 ACL 2002 (Failed)
IPv4 ACL 2004
IPv4 default action: Deny
Table 3 Command output
Field
Interface
Inbound policy
Outbound policy
IPv4 ACL 2001
IPv6 ACL 2002 (Failed)
Description
Interface to which the ACL applies.
ACL used for filtering incoming traffic.
ACL used for filtering outgoing traffic.
IPv4 basic ACL 2001 has been successfully applied.
The device has failed to apply IPv6 basic ACL 2002.
9