Csmp, Set Text Mode Parameters - Fibocom G510 User Manual

+CSCA: "*A"C#",129 /SCA didn't change in storage
OK

7.1.5 +CSMP, Set Text Mode Parameters

This command is a basic command and is used to select values for additional parameters needed when
SM is sent to the network or placed in storage when TEXT mode is selected.
Command Syntax
Set +CSMP=[<fo>[,<
vp>[,<pid>[,<dcs
>]]]]
Read AT+CSMP?
Test AT+ CSMP =?
The following table shows the +CSMP parameters.
<Parameter> Description
<fo> First octet of GSM 03.40. in integer format. For details see +CMGW definitions.
The default value at power-up is 17. (Message type is: SMS-SUBMIT and relative VP
format).
<vp> Validity Period. Depending on SMS-SUBMIT <fo>, TP-Validity-Period-Format bits
setting.
If there is no correlation between the VPF and the VP value. an error message will be
returned.
Either in integer format (see Table) or in time-string format ("yy/MM/dd,hh:mm:ss±zz").
<pid> Protocol-Identifier. The one octet information element by which the SM-TL either refers
to the higher layer protocol being used, or indicates inter-working with a certain type of
telematic device.
"0 - no inter-working, SME-to-SME protocol (default) "Any value between 0-255 will be
accepted.
G5/G6-Family AT Commands User Manual
Response/Action
OK
or:
+CMS ERROR:
<err>
+CSMP:
<fo>,<vp>,<pid>,<dc
s>
OK
OK
Remarks
The set command selects values for
additional parameters needed when SM
is sent to the network or placed in storage
when text format message mode is
selected.
The read command returns the current
parameters value.
The test command just returns OK.
Page 89 of 243