Cfun, Shut Down Phone Functionality - Fibocom G510 User Manual

Read
Test
The following table shows the &D parameters.
<Parameter>
<param>
10.1.10

+CFUN, Shut Down Phone Functionality

It's important to define the module's status in works.
This command shuts down the phone functionality of smart phones and PDAs with phone capabilities in
order to prevent interference from a nearby environment. This enables other functionality to continue to be
used in environments where phone use is either impractical or not permitted. For example, on airplanes
the use of cellular phones is forbidden during the entire flight, but the use of computers is allowed during
much of the flight. This command enables other functionality to continue while preventing use of phone
functionality.
Command Syntax
Set +CFUN=<fun>
G5/G6-Family AT Commands User Manual
AT&D?
AT&D=?
Description
The Module's reaction when the DTR status is changed from ON to OFF.
In ODM:
0,4 Ignores DTR changes
1 Switches the ODM to asynchronous command mode (the ODM
remains connected)
2,3 Disconnects the ODM and returns to the command mode
In GPRS calls:
0,4 Ignores DTR changes
1 Switches the GPRS session to asynchronous command mode (the
session remains connected)
2,3 Deactivates the GPRS and returns to command mode
In MUX and MUX_INIT state:
0-3 Ignores DTE changes
4 Drops the MUX application and returns to PRE_MUX state
The default value is 0.
Response/Action
OK
+CME ERROR: <err>
&D: <param>
&D: (list of supported <param>s)
Remarks
The Set command selects the level
of functionality <fun> in the smart
Page 164 of 243