Mping, Start Ping Execution (Icmp Protocol) - Fibocom G510 User Manual

2,50,6F7665640A3C4120485245463D22687474703A2F2F7777772E676F6F676C652E636F2
E696C2F63786665723F633D505245462533443A544D253344313131393531343833323A5325334
467384A637631
+MIPRTCP:
2,0,426A5458472D30636A5926616D703B707265763D2F223E686572653C2F413E2E0D0A3
C2F424F44593E3C2F48544D4C3E0D0A
+MIPSTAT: 2,1,40

13.1.14 +MPING, Start Ping Execution (ICMP Protocol)

This command allows verifying IP connectivity to another remote machine (computer) by sending one or
more Internet Control Message Protocol (ICMP) Echo Request messages.
The receipt of corresponding Echo Reply messages are displayed, along with round trip times.
Valid IP address must be obtained using AT+MIPCALL command prior to starting ping execution.
Only one ping request execution will be allowed at any given moment.
Command Syntax
Set +MPING=<mo
de>[,<"Destina
tion_IP/hostna
me">[,<count>
[,<size>[,<TTL
>[,<TOS>[,<Ti
meOut>]]]]]]
Unsolicited
Response
Read +MPING?
AT Commands User Manual
Response/Action
OK
or:
+CME ERROR: <err>
+MPING:
<"Destination_IP">,<ty
pe>,<code> [,<RTT>]
+MPING:
<count>,<size>,<TTL>
,<TOS>,<TimeOut>
OK
Remarks
The set command shall send a <count>
Internet Control Message Protocol (ICMP)
Echo Request messages to a target node
defined by <"Destination IP/hostname">
parameter. If <mode> is equal 0, no
parameters trailing <mode> parameter are
allowed, otherwise ERROR message will be
reported to DTE. If <mode> is equal 0, MS
will abort sending Echo Request messages if
ping request is in process, otherwise ERROR
message will be reported to DTE.
The receipt of corresponding ICMP Echo
Reply messages will be displayed within
unsolicited responses, along with round trip
times.
The read command displays currently
selected parameters values for +MPING set
command. If ping sending procedure is
currently in process then user selected
parameters for AT+MPING command will be
Page 218 of 243