F, Set To Factory Defined Configuration - Fibocom G510 User Manual

Example:
AT&V
ACTIVE PROFILE
&C1, &D1, &K3, E1, Q0, V1, X0, S0:0, S3:13, S4:10, S5:8, +CRC: 0
STORED PROFILE 0:
&C1, &D2, &K3, E1, Q0, V1, X0, S0:0, S3:13, S4:10, S5:8, +CRC:0
OK
4.1.7 &F, Set to Factory Defined Configuration
This command restores the factory default configuration profile. The Module only supports one factory
default profile, 0.
Command
Set
Read
Test
The following table shows the &F parameters.
<Parameter>
<value>
G5/G6-Family AT Commands User Manual
...
(profile data)
OK
or
+CME ERROR: <err>
Syntax Response/Action
AT&F<value> OK
or:
+CMS ERROR: <err>
AT&F? <current profile number>
Description
0 Factory default configuration profile. This is the only value supported.
Remarks
The Test command for &F is not
defined by ITU, and therefore is not
supported by the Module. The
Module returns an error.
Page 27 of 243